Thingiverse
Hypercube Evolution Direct Drive Hotend
door rwetzel
4
Downloads
6
Likes
0
Makes
Direct drive hotend assembly for the Hypercube Evolution using Dragon hotend and TBG lite extruder
*Updated May 6 2025*
Highlights:
Assembled to “original” 8mm X-axis rods, 45mm spacing
Compact direct drive, minimal (if any) volume loss
Easier belt assembly and tensioning
Neopixel leds for printer status
EBB36 for lighter/thinner cabling (optional)
Please note:
STL are in recommended print orientation
STEP file of assembly available
Screws, nuts and inserts not represented in 3D file: requires metalic thread inserts, several screw sizes and 5mm diameter pin rods. See fastener list below.
Wiring routing suggestion: please see photos of assembled hotend
*Updated May 6 2025*
Highlights:
Assembled to “original” 8mm X-axis rods, 45mm spacing
Compact direct drive, minimal (if any) volume loss
Easier belt assembly and tensioning
Neopixel leds for printer status
EBB36 for lighter/thinner cabling (optional)
Please note:
STL are in recommended print orientation
STEP file of assembly available
Screws, nuts and inserts not represented in 3D file: requires metalic thread inserts, several screw sizes and 5mm diameter pin rods. See fastener list below.
Wiring routing suggestion: please see photos of assembled hotend
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
