Thingiverse
Hypercube Evolution Enclosed Y End Stop
by papsnoek
292
Downloads
144
Likes
5
Makes
I was tired of scratching my hand on the Y end stop and was worried at some point I would snap off the end stop as the mounting was very small.
I have enclosed the end stop, and the wires are now routed inside the 3030 extrusion for easier cable management.
Enjoy!
PS: Warning, there is a large bridge needed to print this.
Added in 2020 Extrusion file
I have enclosed the end stop, and the wires are now routed inside the 3030 extrusion for easier cable management.
Enjoy!
PS: Warning, there is a large bridge needed to print this.
Added in 2020 Extrusion file
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
