Thingiverse
Hypercube Evolution Enclosed Y End Stop
door papsnoek
292
Downloads
144
Likes
5
Makes
I was tired of scratching my hand on the Y end stop and was worried at some point I would snap off the end stop as the mounting was very small.
I have enclosed the end stop, and the wires are now routed inside the 3030 extrusion for easier cable management.
Enjoy!
PS: Warning, there is a large bridge needed to print this.
Added in 2020 Extrusion file
I have enclosed the end stop, and the wires are now routed inside the 3030 extrusion for easier cable management.
Enjoy!
PS: Warning, there is a large bridge needed to print this.
Added in 2020 Extrusion file
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
