HyperCube Evolution max z endstop

Adding max z endstop to the HEVO will give the possibility to to home (to max).This can be used in case of resume from power down. In case of a Duet controller board you can connect them to the extruder endstop inputs.

You will need 3mm insets for the sensor holder, the screw for the flag and the fixation screw on the side.I.e. 4x 3 mm insets and 4 3 mm screws for each endstop.
idea is to adjust the flag height with the vertical screw and then locking it down with the horizontal screw