Thingiverse
Hypercube_Evolution_Powerswitch_Case
von transwarp2010
115
Downloads
40
Likes
2
Makes
It's a case for a 230V/10A-Powerswitch, to feed my 24V-hypercube-evolution-powersupply.
You can mount it on a 30x30-aluprofile with two M5-screws and M5-hammernuts. The backplate is made to snap into the case.
The powerswitch itself is mountet with two M3-screws and nuts.
Update V2:
Increased case-depth by 5 mm. Increased cable-hole-width. Modified stability of case-cover.
You can mount it on a 30x30-aluprofile with two M5-screws and M5-hammernuts. The backplate is made to snap into the case.
The powerswitch itself is mountet with two M3-screws and nuts.
Update V2:
Increased case-depth by 5 mm. Increased cable-hole-width. Modified stability of case-cover.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
