Hypercube evolution - remote direct drive head

This is my remix of Hypercube Evolution head from heisenberg333 i liked and remote direct drive extruder from fredator i wanted to try.

Both of them have done great job. Send thanks to them too, if you like my remix.

I have edited only rear part of head to fit bowden extruder and to allow easier mount of BLTouch sensor. There are also few modifications on rear mount so this head will fit standard Hypercube Evolution carriage. Original version of head needs custom carriage with 2 more mounting holes.

If you want to use cable chain with standard Hypercube Carriage, you can use my mount for ModelStations cable chain which replaces one of belt clamps.

BLTouch offset is 26mm behind the nozzle (measured on my printed head, this can varry by little).

You will need:
1x E3D v6 hotend (or copy)
1x 40mm fan for E3D hotend
1x 5015 part cooling fan
1x BLTouch sensor (or copy)
1x Remote Direct Extruder with Bondtech Gears (30:1 Gear Ratio)" by fredator (see source for more info)