Thingiverse
Hypercube Evolution Trim Panel Enclosure
door diablex
9
Downloads
1
Likes
0
Makes
Trim panel with counter sunk holes to mount on to 3030 extrusion for 100mm lower bar spacing on the Hypercube Evolution.
This is for 300x300x300 chassis.
The mounting holes will be eliptical. You need to make them round with a hex screw driver.
This is for 300x300x300 chassis.
The mounting holes will be eliptical. You need to make them round with a hex screw driver.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
