Thingiverse
HyperCube spinner (R188 Bearing)
von magonegro
10
Downloads
8
Likes
0
Makes
Hypercube fidget spinner (30mm), continuing my series of small spinners. The first interdimensional spinner in the world. Don't ask me if dimensional weirdness start to happen at your fingertips heheh...
Use a R188 Bearing (4.8 mm tall) and baseplate support for printing.
Recommended print in PLA due to little hangouts that could break in ABS without layer cooling.
Sand it a bit, use a drop of glue to fix the bearing and caps an you are done.
Previous spinners here:
https://www.thingiverse.com/thing:2386158
https://www.thingiverse.com/thing:2381990
Enjoy.
UPDATE (28-JUN-2017): Increased tolerances of top and bottom parts for a better build. Corrected STL's base alignment.
Use a R188 Bearing (4.8 mm tall) and baseplate support for printing.
Recommended print in PLA due to little hangouts that could break in ABS without layer cooling.
Sand it a bit, use a drop of glue to fix the bearing and caps an you are done.
Previous spinners here:
https://www.thingiverse.com/thing:2386158
https://www.thingiverse.com/thing:2381990
Enjoy.
UPDATE (28-JUN-2017): Increased tolerances of top and bottom parts for a better build. Corrected STL's base alignment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
