Thingiverse
HyperX Cloud II Headset Stand
von MitchellMakes
10
Downloads
10
Likes
1
Makes
A stand I modelled for my HyperX Cloud II Headset.
Shouldn't need supports, I printed at 0.1mm layer height.
This was a "rush" job, and somethings could have been done better. I have started on a parametric version, but not sure if I'll end up completing it.
Shouldn't need supports, I printed at 0.1mm layer height.
This was a "rush" job, and somethings could have been done better. I have started on a parametric version, but not sure if I'll end up completing it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
