Thingiverse
HyperX Cloud II strap guide
di AirsoftGuy
11
Download
16
Likes
0
Makes
This is a pair of CAD designed parts which are replacements for a maybe broken original part for the HyperX Cloud II.
The outer part needs to be layed down flat, because the part was designed straight but later on I made a 4° slope on the back so it's a bit thinner this way.
I could screw back them together with the original screws, but watch out! Don't screw it too deep, it will come out on the other side!
These parts are designed to the RIGHT site. Mirror them in order to fit better on the left (cable to the driver).
The outer part needs to be layed down flat, because the part was designed straight but later on I made a 4° slope on the back so it's a bit thinner this way.
I could screw back them together with the original screws, but watch out! Don't screw it too deep, it will come out on the other side!
These parts are designed to the RIGHT site. Mirror them in order to fit better on the left (cable to the driver).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
