i3 Mega 20mm Riser base

2018-12-12 added my gcode files from Jan/Feb 2018. Use at your own risk.

2018-05-24 added Fusion 360 and step files for easier remixing. Hopefully I will get back to modifying this again, but for now, happy remixing.

2018-02-04
In my quest to make my printer more quiet, I came up with this idea since the i liked the power supply cover by ml_blh. (https://www.thingiverse.com/thing:2715000). I installed his cover and 2 new fans. Just doing that decreased the frequency of the PSU fan on time. (also quieter fans are more quiet.) The only trouble with the PSU cover was the base bottom cover did not fit, and I still needed to put the feet on some blocks so the cross bar would not touch the table.

This base is 20 mm tall and attaches with the standard screw locations. (hopefully. I printed the first section with 3mm holes and had to open them up with a drill, but since then have changed the model to 3.5mm) I recommend 20mm long screws and don't tighten them too hard or you