Iambic Paddles (Narrow Version)

If you like what you see here, consider leaving a tip.

Remixed from an excellent design by Thingiverse user and certified amateur radio operator Loren Butler (V01PWF), the intent of this project was to make a set of 3D printable iambic paddles that were as portable as possible, yet comfortable enough to use at a desk. This is the narrow version of these paddles and are not base mountable. The base mountable version is 10 mm wider and can be found here, and a mini version can be found here.

Hardware Used:

3x 6-32 x 1 inch phillips flat pan head screws for paddle pivots and ground contact
2x 6-32 phillips flat pan head screws trimmed to 11.5mm thread length for paddle contacts
2x 6-32 nuts/springs and washers for paddle contact screws
4x 6-32 1/4 inch phillips flat pan head screws for attaching the cover
1x 1/8 inch stereo jack or hot glue
1x Spring from a retractable pen (3.5mm outer diametre, 10mm length)
or 2x neodymium magnets
or 1x 3D printable spring designed by M