IC 705 Box

I've had this idea stweing in the back of my head for awhile now, but I was too lazy to do it myself. Someone in a facebook group posted their version but refused to share the models, so I hacked this out in tinkercad in about an hour.This is meant as more of a proof of concept, and I leave it to the community to develop this further if they desire.Using 100% infill will result in an immensely strong print, but will consume about 800 grams of filament, so make sure you have a fresh roll on unless you want to cut the infill. I'll leave that to your discretion.Printed on an ender 5 plus.The large hole is sized and countersunk for my anderson panel mount, the upper small one is meant for a standard ½ inch BNC panel mount, and the lower right smaller hole is meant to pass through the cord for the 705's speaker mic. It's sized to accept a PG7 cable gland, if desired.You'll need four M4x14 screws to mount it using the 705's screw holes in the bottom.Note that rather than flatten the bottom c