Thingiverse
Ice Bubbles
35
Download
55
Likes
0
Makes
These “Ice Bubbles” are designed for spiralized printing to maximize translucency and minimize material and print time. These are great prints for your clear or translucent filaments!
See here for video: https://youtu.be/xJ5POHSJL1I
See here for stable download and more sizes: https://than.gs/m/960766
You will need to print two pieces to make one ball. When printed with a 0.5mm nozzle, the balls require 3g, 5.4g, 8.4g of filament. That means 1kg of filament you could make approximately 333 small Ice Balls!
Here are some recommendations for spiralized printing:
- Use thick layer heights, 0.2mm or greater
- Set your “Bottom Layer” to 1
- Try using a skirt for bed adhesion, but if that is not working then try a brim. You will just have to remove the brim afterwards
- If you get funny stringing on the top layer, try moving the z-seam alignment around
See here for video: https://youtu.be/xJ5POHSJL1I
See here for stable download and more sizes: https://than.gs/m/960766
You will need to print two pieces to make one ball. When printed with a 0.5mm nozzle, the balls require 3g, 5.4g, 8.4g of filament. That means 1kg of filament you could make approximately 333 small Ice Balls!
Here are some recommendations for spiralized printing:
- Use thick layer heights, 0.2mm or greater
- Set your “Bottom Layer” to 1
- Try using a skirt for bed adhesion, but if that is not working then try a brim. You will just have to remove the brim afterwards
- If you get funny stringing on the top layer, try moving the z-seam alignment around
DaveMakesStuff pubblica anche su
7 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
