Thingiverse
Ice Bubbles
von DaveMakesStuff
35
Downloads
55
Likes
0
Makes
These “Ice Bubbles” are designed for spiralized printing to maximize translucency and minimize material and print time. These are great prints for your clear or translucent filaments!
See here for video: https://youtu.be/xJ5POHSJL1I
See here for stable download and more sizes: https://than.gs/m/960766
You will need to print two pieces to make one ball. When printed with a 0.5mm nozzle, the balls require 3g, 5.4g, 8.4g of filament. That means 1kg of filament you could make approximately 333 small Ice Balls!
Here are some recommendations for spiralized printing:
- Use thick layer heights, 0.2mm or greater
- Set your “Bottom Layer” to 1
- Try using a skirt for bed adhesion, but if that is not working then try a brim. You will just have to remove the brim afterwards
- If you get funny stringing on the top layer, try moving the z-seam alignment around
See here for video: https://youtu.be/xJ5POHSJL1I
See here for stable download and more sizes: https://than.gs/m/960766
You will need to print two pieces to make one ball. When printed with a 0.5mm nozzle, the balls require 3g, 5.4g, 8.4g of filament. That means 1kg of filament you could make approximately 333 small Ice Balls!
Here are some recommendations for spiralized printing:
- Use thick layer heights, 0.2mm or greater
- Set your “Bottom Layer” to 1
- Try using a skirt for bed adhesion, but if that is not working then try a brim. You will just have to remove the brim afterwards
- If you get funny stringing on the top layer, try moving the z-seam alignment around
DaveMakesStuff veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
