Ikea Gulliver risers

A height adjustment/riser for Ikea Gulliver kid bed. Place two of these below the feet in the bed end to change the angle of the bed.

I have printed and tested the "bottom_40mm" and the "square 70x30mm" screw. The rest of the files are uploaded by request to fit more beds and to give room for higher lift. I have not tested these but the only difference is thread lenght. Give feedback if you test them and something is not working or they are to unstable.

The screw can be screwed down in the base so that there is about 20mm lift at the lowest. Base is 5mm thick below the threads and the screw has 15mm from the flat surface where the bed feet rest to the bottom of the screw. The thread lenght is indicated in the file name so a 40mm long thread will mean that the base is 45mm total height and with the screw intersecting with 10mm of threads that gives a lift of 50mm from the floor at max and 20mm at minimum. 150mm threads would give a 160mm lift.

The screw that has 70x30mm cut