Thingiverse
Imperial Probe Droid - Probot
door alpokemon
2.1k
Downloads
1.3k
Likes
22
Makes
This is the robot from the icy snowy planet in the Fifth movie and not screen accurate. Model is finished and print verified. This model is best printed at 100% scale on FDM. SLA/SLS - go as small as you'd like. I find on FDM, 120% to 130% scale works really well and all the details show super nicely.
Dec 27, 2017 Update - Added a new bottom which changes the orientation fo the legs and some bottom hardware. See instructions below. Enjoy.
Nov 27, 2017 - Added a new head with a rounded top and better antenna nubs. Also added a new body top and a thinner lower body. I removed all the split heads because the split along the seam on the model - prints well but makes it harder to assemble. I would suggest splitting it vertically between some of the eyes and then laying that edge to the build plate.
Printing the Model:
Print 3 sets of the LongLeg 1,2 &3
Print 2 sets of the ShortLeg 1 & 2
Print 5 of the claws of any mix and match between the 3 styles
Print one head of
Dec 27, 2017 Update - Added a new bottom which changes the orientation fo the legs and some bottom hardware. See instructions below. Enjoy.
Nov 27, 2017 - Added a new head with a rounded top and better antenna nubs. Also added a new body top and a thinner lower body. I removed all the split heads because the split along the seam on the model - prints well but makes it harder to assemble. I would suggest splitting it vertically between some of the eyes and then laying that edge to the build plate.
Printing the Model:
Print 3 sets of the LongLeg 1,2 &3
Print 2 sets of the ShortLeg 1 & 2
Print 5 of the claws of any mix and match between the 3 styles
Print one head of
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
