Impossible Pass Through - Version 3

This is my updated Version 3 of an impossible pass through. I upped the amount of splines from 8 to 10 Printed in Orca Slicer on a Bambu X1C with a Smooth PEI Plate.Layer height .16mmThree walls 10% Gyroid infill Print in place. The inner piece acts as a support mechanism for the outer piece. If you don't do this, the sections on the outer tube are too small and flex during print, which leads to a failure near the end. I uploaded the 3MF file from Orca slicer for those that use Orca slicer.