Thingiverse
Improved feets FDM
von 3DAmsterdam
12
Downloads
7
Likes
0
Makes
If you print the robot with FDM it is easier to print the feets in one piece.
Getting the foot pads in the feets is very difficult. The feets shrinks more than the pads.
So better to print them in one piece. Depending on your infill percentage it takes even less material.
Getting the foot pads in the feets is very difficult. The feets shrinks more than the pads.
So better to print them in one piece. Depending on your infill percentage it takes even less material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!