Thingiverse
Improved Lithophane Cube
von refleks
546
Downloads
306
Likes
1
Makes
This is an update to my original lithophane cube. It is designed to accept a 3dp.rocks generated 100x100 Lithophane with a 4mm border and default thickness settings. Also included is a 100x150 version (taller).
***Changes***
The original was designed for 12v LED strips, and had an octagonal center pylon, with each flat face designed to accept a cut part of the LED strip. However, cutting them and soldering / wiring them all together is a real pain! Spiraling them up the pylon would be much better, so the octagonal design is not ideal. Additionally, the old design had a hollowed out base to accept the 12v adapter, but that required substantial supports.
Based on feedback from the community, the new design has a flat bottomed base and interchangeable round pylons (just superglue them or hot glue the one you prefer in) so that an LED strip can spiral around it. I would recommend a 5v USB LED strip rather than the 12v so no barrel adapter is needed. The inner diameter of
***Changes***
The original was designed for 12v LED strips, and had an octagonal center pylon, with each flat face designed to accept a cut part of the LED strip. However, cutting them and soldering / wiring them all together is a real pain! Spiraling them up the pylon would be much better, so the octagonal design is not ideal. Additionally, the old design had a hollowed out base to accept the 12v adapter, but that required substantial supports.
Based on feedback from the community, the new design has a flat bottomed base and interchangeable round pylons (just superglue them or hot glue the one you prefer in) so that an LED strip can spiral around it. I would recommend a 5v USB LED strip rather than the 12v so no barrel adapter is needed. The inner diameter of
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!