Thingiverse
Insect Drinking Station
von no0ny
7
Downloads
5
Likes
0
Makes
A little drinking station for any insects around the garden
Put them in the base of the plant, add a splash of water and let the pollinator profited a little source of water for their journey
Please note that you have to rotate it 90° before print it
You can adjust the size, it's 6cm in height but you can reduced it to 4.5 without any problem
At the original size, a print of 4 is done in less than an Hour
Put them in the base of the plant, add a splash of water and let the pollinator profited a little source of water for their journey
Please note that you have to rotate it 90° before print it
You can adjust the size, it's 6cm in height but you can reduced it to 4.5 without any problem
At the original size, a print of 4 is done in less than an Hour
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
