Thingiverse
Insert Sign
9
Downloads
12
Likes
0
Makes
This is an insert sign I designed for at work, I could not find anything like it on thingiverse so I designed my own.
**_insert-sign-body.stl_**
-Prints well at 0.15mm and 0.2mm
-Support are built into model and just need removed and cleaned up
-Note 1: The size of the header was enlarged and the photo is of the original prototype so refer to .stl for actual size
**_sign-insert.stl_**
-Add text using whatever software you prefer (I made mine 1mm deep)
-Add a filament swap at the appropriate layer height (use contrasting colors for best visibility)
-Note 2: For the text leave enough spacing around the insert so when inserted into the sign body all text is visible
-Note 3: If centering the text, shift everything slightly to the right as the dead center of the insert is not the center when viewed through the sign's window
**_insert-sign-body.stl_**
-Prints well at 0.15mm and 0.2mm
-Support are built into model and just need removed and cleaned up
-Note 1: The size of the header was enlarged and the photo is of the original prototype so refer to .stl for actual size
**_sign-insert.stl_**
-Add text using whatever software you prefer (I made mine 1mm deep)
-Add a filament swap at the appropriate layer height (use contrasting colors for best visibility)
-Note 2: For the text leave enough spacing around the insert so when inserted into the sign body all text is visible
-Note 3: If centering the text, shift everything slightly to the right as the dead center of the insert is not the center when viewed through the sign's window
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
