Thingiverse
Insta360 x3 Loop Mount
door Secret-Asian-Man
9
Downloads
20
Likes
0
Makes
- Sliced with CURA.
- Print with 100% infill.
- Print with support at 36 degrees. Screw may need some light cleanup, but screwing it in the camera should re-tap it.
- Recommended to print with a brim.
- Takes about 30mins to print with my slow settings.
- Not tested with PLA, but should work fine.
- Print with 100% infill.
- Print with support at 36 degrees. Screw may need some light cleanup, but screwing it in the camera should re-tap it.
- Recommended to print with a brim.
- Takes about 30mins to print with my slow settings.
- Not tested with PLA, but should work fine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!