Intel cpu cooler pushpin

I designed this replacement pushpin for a stock Intel LGA1151 CPU cooler after the original motherboard mounting pins broke.
It may also be compatible with other standard Intel stock coolers.

I used PLA and I recommend printing this horizontally with supports. Printing it horizontally gives the pin much more mechanical strength.
You can print it vertically without supports, but it will likely snap along the layer lines under pressure.

Depending on your printer's tolerances, the pin might be a tight fit. If the original other part of the pushing pin doesn't push down all the way, simply use a file or sandpaper on the outer section of the 3d printed part that passes through the motherboard until it slides smoothly.