Slicer Discord
Intel NUC - Stack Ring – 3D-printbaar model van Thingiverse Thingiverse

Intel NUC - Stack Ring

door tophe75
92 Downloads
71 Likes
2 Makes
Model downloaden
If you are like me, you like to mess around with computers.
I also like to have my own Virtual Lab and in order to control heat, I came up with this ring, as the Intel NUC sucks air in from the bottom and blows it out in the back.

If you want to build your own Nano Lab there is an excellent guide about it here (not by me): http://www.tekhead.org/blog/2013/01/nanolab-running-vmware-vsphere-on-intel-nuc-part-1/

As of now my Nano Lab runs on three VMWare hosts (two of them Intel NUC's) and also iSCSI LUN from my NAS (Synology 414) all connected through a Netgear GS108Ev2 switch with multiple vlans.

Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

tophe75 publiceert ook op

9 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie