Thingiverse
interchangeable triangles pendant
43
Download
47
Likes
0
Makes
*** UPDATED *** I found the hanging loop to be too small and a little brittle so have changed the design, plus made the connecting pin holes larger as my triangles weren't always fitting. Use "Triangle Base Large loop" for this version.
This is a necklace which can change to fit your mood / outfit!
Just print lots of triangles and then swap them about whenever you feel like it :)
Necklace consists of:
- a base part with three holes and a hidden tube on the back for threading the chain or cord - print 1
- a top triangle piece - print 1
- a lower triangle piece - print 2
Then just snap them together in your chosen colour scheme.
I printed these with no special settings on a Flashforge finder. The peg fits closely, although I found that my special PLAs (wood, glitter etc) were a little less precise and more tricky to fit. However, with a bit of persuasion, they went in.
Feedback welcome, as I have no idea if the results will be as good on other printers. I
This is a necklace which can change to fit your mood / outfit!
Just print lots of triangles and then swap them about whenever you feel like it :)
Necklace consists of:
- a base part with three holes and a hidden tube on the back for threading the chain or cord - print 1
- a top triangle piece - print 1
- a lower triangle piece - print 2
Then just snap them together in your chosen colour scheme.
I printed these with no special settings on a Flashforge finder. The peg fits closely, although I found that my special PLAs (wood, glitter etc) were a little less precise and more tricky to fit. However, with a bit of persuasion, they went in.
Feedback welcome, as I have no idea if the results will be as good on other printers. I
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
