Thingiverse
Interlocking Relief plates
von tjatkings
9
Downloads
10
Likes
0
Makes
Here is a design for printmaking plates that I have not yet tested.
It has an interlocking system based on a cylindrical peg, rather than a square peg as I have been using to make prints currently. At times I have found the interlock to be a hindrance to printing so I have cut them off with a knife, should the need arise.
It has an interlocking system based on a cylindrical peg, rather than a square peg as I have been using to make prints currently. At times I have found the interlock to be a hindrance to printing so I have cut them off with a knife, should the need arise.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
