Thingiverse
iot octopus case
von sumpfing
11
Downloads
10
Likes
2
Makes
Case for iot octopus
https://www.tindie.com/products/FabLab/iot-octopus-badge-for-iot-evaluation/
the lipo version is 1 mm higher.
ttn rottal-inn
https://www.thethingsnetwork.org/community/rottal-inn/
v7: 29.06.2019: made slits lower due to bending of the case
v8: 01.07.2019: optimized slits and made the non-lipo version lower
https://www.tindie.com/products/FabLab/iot-octopus-badge-for-iot-evaluation/
the lipo version is 1 mm higher.
ttn rottal-inn
https://www.thethingsnetwork.org/community/rottal-inn/
v7: 29.06.2019: made slits lower due to bending of the case
v8: 01.07.2019: optimized slits and made the non-lipo version lower
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!