iPad mini 2 wall mount
von mkc2
29
Downloads
17
Likes
0
Makes
Made this wall mount for my iPad mini 2 to use for CCTV monitor.
4 shells, 0.2 mm layer, 10% infill.
I put 6 magnets in the back to stick to a metal sheet, 15mm X 3mm magnets used.
Cut some metal sheet about 1 mm thick then drill a hole for the cable to go through, drill some small holes and mount to the wall.
4 shells, 0.2 mm layer, 10% infill.
I put 6 magnets in the back to stick to a metal sheet, 15mm X 3mm magnets used.
Cut some metal sheet about 1 mm thick then drill a hole for the cable to go through, drill some small holes and mount to the wall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!