Thingiverse
iPhone Stand
by DPS_Design
7
Downloads
3
Likes
1
Makes
I needed a stand to hold my iPhone XS Max in it's battery case.
I made it 105mm wide - so portrait works but landscape is awesome.
The slot the phone sits into is just over 19mm deep. I left a cable access hole in case you plug yours in during portrait mode. And I added holes for the mic and speaker. I also left a slot to access the bottom of the screen for the pull-up menu.
I extruded slots on the front and back to save on plastic. Slots everywhere...
I'm betting that the size might even be ok to hold my iPad.
I made it 105mm wide - so portrait works but landscape is awesome.
The slot the phone sits into is just over 19mm deep. I left a cable access hole in case you plug yours in during portrait mode. And I added holes for the mic and speaker. I also left a slot to access the bottom of the screen for the pull-up menu.
I extruded slots on the front and back to save on plastic. Slots everywhere...
I'm betting that the size might even be ok to hold my iPad.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
