IPod Mini Back Plate

This is a back plate for a bluetooth mod for the IPod Mini (1st and 2nd Gen), you can stick any bluetooth transmitter with your favorite adhesive to the back and use the headphone jack on the IPod. Printed in Inland PLA with the Generic PLA Preset on a P1S. DISCLAIMER: Should be scaled correctly to be a very snug fit, i'd do a test and print for 5 minutes then cancel the print to test fit. If its too secure you can open it up a bit with you fingers to slide it off and slide it back on. Hasn't scratched my case either but since it is friction fit i'd pry it open a bit until its where you want it.