IPSC Target Paster

For all of my Competition Shooters out there tired of fumbling with the paster rolls when taping up targets, this is a paster tool that's not $70. Print it, pull the supports off of the spool holder catches. Compress the catch slightly to load the paster roll and feed the pasters up through the nose of the tool. The first couple, you might pull off by hand, but once you have a tail, you can pull it through against that angle as seen in the GIF. The paster will peel off of the tape about halfway, allowing you to set it against the target and then press it into place using the rounded nose of the tool. This takes a little bit of muscle memory and repetition to figure out, but so far this is been a drastic improvement to pasting by hand. I like to hold it a little bit sideways so I can see the paster better, but there is a hole up through the nose where you can see it as well. The two things to watch out for is pulling the tail too hard so it rips at the sharp angle, or pulling it too har