Thingiverse
IR Head Tracking "Cap Version"
von iTrooper
40
Downloads
20
Likes
1
Makes
This is a remix of Crispy001's "FreeTrack 3 Point Hat Model".
I found it would take about 2hrs to build the original design and it would possibly require supports. I've made some alterations to the model to allow it to be easily printed in two parts without supports, as well as reducing the print time to around 30mins (when done at 0.3).
Additionally I've added some grooves where the wires can sit in and also tunneled a path inside the L piece for the wires to go up to the top LED. Then threw in a bit of hot glue just to hold the wires in place, it doesn't have to look pretty, it just has to work!
I tip my hat to Crispy001 for his original design.
I found it would take about 2hrs to build the original design and it would possibly require supports. I've made some alterations to the model to allow it to be easily printed in two parts without supports, as well as reducing the print time to around 30mins (when done at 0.3).
Additionally I've added some grooves where the wires can sit in and also tunneled a path inside the L piece for the wires to go up to the top LED. Then threw in a bit of hot glue just to hold the wires in place, it doesn't have to look pretty, it just has to work!
I tip my hat to Crispy001 for his original design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
