Slicer Discord
IR Source – 3D-Druckmodell von Thingiverse Thingiverse

IR Source

von allardjd
1 Downloads
1 Likes
0 Makes
Zum Modell
IR Source

This device is essentially an IR flashlight with a single IR LED. UV light sources are a dime a dozen, but IR sources are thin on the ground, probably because no one ever needs one anyway. None the less, I've made one. I built in a couple of extra features for no good reason that I can think of other than that I wanted to.

EDIT: 5/26/24 - Complementary IR Detector now posted here...

https://www.thingiverse.com/thing:6637888

There are no on-board batteries. Power should be 5-6 V DC to the 5.5 mm barrel jack with the pin positive. The device is push-button activated; there's no hard on-off switch.

If you like the battery box that's visible in a couple of the images it's at...

https://www.thingiverse.com/thing:6036477

There is a red LED in the cover to provide some confirmation that there is in fact current through the IR LED.

The pot controls current through the LED pair, which are in series. With the specified supply voltage, the current range is
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

allardjd veröffentlicht auch auf

62 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen