Iris Keyboard

Case for each side of an Iris Keyboard kit (built/tested with v2.6 PCBs)

Features a thick integrated switch plate and a base that provides a 6 deg incline.

PARTS:
* [Iris PCB kit](https://keeb.io/collections/keyboard-pcbs/products/iris-keyboard-split-ergonomic-keyboard?variant=8034004860958). Includes PCB and various components
* [2x Pro Micros](https://keeb.io/products/pro-micro-5v-16mhz-arduino-compatible-atmega32u4)
* [TRRS Cable](https://keeb.io/products/trrs-cable?variant=8139444519018)


PRINTING:

Print the bases upside down and turn on supports (supported bridges as well if needed) so that the cutouts for your ProMicro and TRRS jacks don't sag.

Print the top portion right-side-up with supports. If you don't like using supports or your printer doesn't do well with them, you can split the top portion horizontally into two pieces 8.5mm from the top face. If you go this route, print the lower half upside-down and the upper half right-side-up and then chemically w