iStick Pico stand

This is just a simple stand I designed in about an hour. It keeps my mod from constantly falling over its side.
It can hold an iStick Pico or other similar mods safely on the desk.

**Features:**
- reversible, as all things should be
- minimum material required (11-14g)
- very stable
- easy to print
- lots of clearance, in case your mod has a sleeve
- can be customized at: https://cad.onshape.com/documents/b33cb2ed71ba0577a1ed1168/w/c7e02266d760dfef2ab87116/e/9e84b5bd9155c11d2405ccff
- **tested**

**Instructions:**
Printed in PLA, 15% infill, no rafts or support. I think it took about 40 minutes.

**Design notes:**
Not very pretty and could use a bit of work on the fit and curves. I took some mod measurements and eyeballed the radius, then added about 1mm of clearance.
I still don't know how to design symmetric organic objects in OnShape, so the curves were done with fine-tuned fillets.
I would add some chamfer or fillet on the inner USB top edges, but I was afraid it