ITX case

Every piece can be printed on a 220mmx220mm bed

This is the fist thing I've designed so any feedback would be much appreciated

GPU mounting needs to be glued, only done so things can be printed with minimal supports

Feet are designed to be printed out of flexible plastic and pushed into the bottom panel it will require 2 of the feet to be mirrored in when sliced

Fixings I used to screw everything together
https://www.amazon.co.uk/dp/B075WY5367?psc=1&ref=ppx_yo2ov_dt_b_product_details
The nuts may need a drop of glue to hold them in but can be fine without

If I change anything it will be to fix where the front panel attaches to the bottom panel to make it the same as the top