ITX case (with PicoPSU support)

This is a remix of the [ITX case from msvprinting](https://www.thingiverse.com/thing:3850905). I closed the holes on the side to speed up the printing process.

Original discription:
This is my take on a mini stx Louqe Ghost S1. It houses a mini itx motherboard and a pico psu.

I have found if you take the shroud off an ssd it will tuck in the back.

The cooler clearance is around 58mm, something like the Is-60 from Id Cooling or the Akasa NeroLX2 will work well (these are the only ones I've tested, many more will work).

I have provided a hole at the back for the psu connector, this may have to be drilled out. I have left the front blank with no button hole so that can be customised however you want, I drilled a hole and used an anti-vandal switch.

Overall measurements are around 200x185x60mm so can easily be printed on something like an Ender 3. The only supports needed will be for the I/O shield.

Screws used throughout are 3.5mm (No.6) by 13mm countersunk.

These ca