JAEC - Just Another Electronics Case

When I put my Ender 3 inside an IKEA PLATSA (120x80x55 cm) I felt the need to get an enclosure for my electronics so I could get them cool and more room for more mods :)

This project is far from being perfect but is fills my needs.

I ended up also designing a way go get cool air from the outside to only cool the electronics and some filters to get some hot air out.

The contents of the box are:
- BIQU SKR v1.1
- Odroid C2 (same mounting of an RPi)
- 12v brick to power the Odroid and the LEDs independently of the Printer
- 10cmx10cm PCB for soldering dc-dc buck converters and other things that I might need
- 2xRelay board
- BED MOSFET
- Meanwell Ender3 24v PSU