Thingiverse
jar
von 3ona
12
Downloads
9
Likes
0
Makes
hole for the magnet at the bottom, it is necessary to close the seal if it is necessary for the intended use.
дырка с низу для магнита, нужно перед печатью закрыть, если планируете использовать по назначению
дырка с низу для магнита, нужно перед печатью закрыть, если планируете использовать по назначению
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!