Thingiverse
JDFPV HOVERCRAFT
door JDFPV
27
Downloads
17
Likes
0
Makes
Finally Getting A Chance To Share My Hovercraft Design
Super Fun Project that i hope Everyone Enjoys. Video above to give details on this Setup. https://youtu.be/C-BwKlPX_bk
All that is needed is: 1 - 9 gram servo
2 - esc 20 to 30 amps
1 - 1306 motor
1 - 1806 motor
2 - heavy duty paper clips or heavy gauge wire
1 - RX
1- 5v bec
17-20 hours worth of printing
The main body took about 13 hours to print with supports.
Rear motor mount needs supports as well.
Base requires no supports.
Note: Set Limits on the servo. If not when you turn too sharp it will allow the rear motor prop to cut into the bag.
Enjoy! Any questions please hit me up on Youtube or My Facebook
Super Fun Project that i hope Everyone Enjoys. Video above to give details on this Setup. https://youtu.be/C-BwKlPX_bk
All that is needed is: 1 - 9 gram servo
2 - esc 20 to 30 amps
1 - 1306 motor
1 - 1806 motor
2 - heavy duty paper clips or heavy gauge wire
1 - RX
1- 5v bec
17-20 hours worth of printing
The main body took about 13 hours to print with supports.
Rear motor mount needs supports as well.
Base requires no supports.
Note: Set Limits on the servo. If not when you turn too sharp it will allow the rear motor prop to cut into the bag.
Enjoy! Any questions please hit me up on Youtube or My Facebook
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
