Thingiverse
JellyFish
door Babouch
71
Downloads
79
Likes
0
Makes
The idea of this project was to use 3, 3.5 and 4inch props with 1407-3600kv brushless motors on a frame as short as possible.
We ended up with the "JellyFish", based on an awsome 145mm frame designed by my good friend Brax and a "Jelly" pod modelised by myself.
The pod requires to be printed in flex material so the camera and Vtx can fit in without any problem, this provides also a good protection against crashes.
Components:
Frame
https://armattanproductions.com/pages/product_details/8108
Battery
4S 850mah - 4S 650mah - 3S 500mah
-
Thanks to Microdure and Brax for their precious help and printing of the prototype
https://www.thingiverse.com/Microdure/about
https://www.thingiverse.com/Brax/about
We ended up with the "JellyFish", based on an awsome 145mm frame designed by my good friend Brax and a "Jelly" pod modelised by myself.
The pod requires to be printed in flex material so the camera and Vtx can fit in without any problem, this provides also a good protection against crashes.
Components:
Frame
https://armattanproductions.com/pages/product_details/8108
Battery
4S 850mah - 4S 650mah - 3S 500mah
-
Thanks to Microdure and Brax for their precious help and printing of the prototype
https://www.thingiverse.com/Microdure/about
https://www.thingiverse.com/Brax/about
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!