Thingiverse
JellyFish
von Babouch
71
Downloads
79
Likes
0
Makes
The idea of this project was to use 3, 3.5 and 4inch props with 1407-3600kv brushless motors on a frame as short as possible.
We ended up with the "JellyFish", based on an awsome 145mm frame designed by my good friend Brax and a "Jelly" pod modelised by myself.
The pod requires to be printed in flex material so the camera and Vtx can fit in without any problem, this provides also a good protection against crashes.
Components:
Frame
https://armattanproductions.com/pages/product_details/8108
Battery
4S 850mah - 4S 650mah - 3S 500mah
-
Thanks to Microdure and Brax for their precious help and printing of the prototype
https://www.thingiverse.com/Microdure/about
https://www.thingiverse.com/Brax/about
We ended up with the "JellyFish", based on an awsome 145mm frame designed by my good friend Brax and a "Jelly" pod modelised by myself.
The pod requires to be printed in flex material so the camera and Vtx can fit in without any problem, this provides also a good protection against crashes.
Components:
Frame
https://armattanproductions.com/pages/product_details/8108
Battery
4S 850mah - 4S 650mah - 3S 500mah
-
Thanks to Microdure and Brax for their precious help and printing of the prototype
https://www.thingiverse.com/Microdure/about
https://www.thingiverse.com/Brax/about
Babouch veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!