Thingiverse
Joint case
by joda6876
20
Downloads
15
Likes
1
Makes
Simple Joint case designed by me.
Smellproof and mostly waterproof.
Print the cone part upside down (opening facing down) and use a brim or raft.
Otherwise it will fall over while printing.
The cap can be printed without extra built plate adhesion.
On 0.25res and 20%infill it should take about~
Cone: 1:25h
Cap: 12min
The cone is also wide enough to house big activ filters
Smellproof and mostly waterproof.
Print the cone part upside down (opening facing down) and use a brim or raft.
Otherwise it will fall over while printing.
The cap can be printed without extra built plate adhesion.
On 0.25res and 20%infill it should take about~
Cone: 1:25h
Cap: 12min
The cone is also wide enough to house big activ filters
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
