Joystick

Arcade joystick case. Sanwa-clone stick and 30mm buttons from Amazon.

You will need M5*screw and nuts to mount the joystick. Various M3 screws and nuts to secure the rest.

I printed this on an Ender 3 V2. It's divided into two bottom and two top parts - 4 parts all together. Assembly will require M3 screws and nuts to bolt together. The top and bottom attach together with M3 screws; I've put slots into the posts on the top portion for the screws to go into. You probably could get by without the nuts, but the connection may weaken over time.

I tried to keep the height as low as could go - 41mm. It is a very tight fit inside with the buttons I used. The shaft of the joystick protrudes about 2mm from out the bottom of the case. Also note that I left a big hole there; enough to gain access to joystick gate. The plan is to purchase a 2mm sheet of PVA foam and glue it to the bottom of the case. This will offset the 2mm from the joystick shaft and act as a non-slip base.

The phot