Thingiverse
JST indicator cap
von julienc01
16
Downloads
17
Likes
0
Makes
I designed my own JST cap because other ones found on thingiverse didn't suit me totally.
Very easy design, but I took a special care on using good dimensions, so that the insertion is done without forcing while keeping well in place.
This one uses very few plastic too !
Recommended resolution : 0.20 mm
Very easy design, but I took a special care on using good dimensions, so that the insertion is done without forcing while keeping well in place.
This one uses very few plastic too !
Recommended resolution : 0.20 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
