Jumper T16 Stick Knobs
por claytonbakerjr
6
Descargas
1
Likes
0
Makes
Basic set of knobs for the Jumper T16.
I printed mine at 50% infill and also used a 4mm brim to help secure them to the table better.
There are 3 different sizes...23mm 26mm and 29mm tall. There is also a 3mm hole that is 15mm deep so that you can tap the threads in.
Print 2 sets if you want 2 of the same knobs on both sticks.
I used a 23 on my throttle and a 26 on my elevator stick.
I printed mine at 50% infill and also used a 4mm brim to help secure them to the table better.
There are 3 different sizes...23mm 26mm and 29mm tall. There is also a 3mm hole that is 15mm deep so that you can tap the threads in.
Print 2 sets if you want 2 of the same knobs on both sticks.
I used a 23 on my throttle and a 26 on my elevator stick.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
