Thingiverse
Junction box
door arcy2119
94
Downloads
89
Likes
1
Makes
I present to your attention a junction box for electrical installation!
Made on the basis of an already existing box in the sizes I need. In the process of modding, another version was performed: it has a body longer by 10 mm and lower by 5 mm relative to the original. This is done because the wall is very thin and there is a risk of drilling through it at the time of installation.
I didn't find boxes with such sizes in my city, so a couple of hours of modeling solved my problem.
The printing was carried out in layers of 0.2 mm.
The nozzle thickness is 0.4 mm.
The settings that activate overhangs are included, the angle is 50 degrees. You can print without these settings.
Filling 15%.
The number of walls is 4.
The bridge settings are activated.
The printing speed of the walls is 42.5.
The filling speed is 60.
I wish you all successful printed models!
Made on the basis of an already existing box in the sizes I need. In the process of modding, another version was performed: it has a body longer by 10 mm and lower by 5 mm relative to the original. This is done because the wall is very thin and there is a risk of drilling through it at the time of installation.
I didn't find boxes with such sizes in my city, so a couple of hours of modeling solved my problem.
The printing was carried out in layers of 0.2 mm.
The nozzle thickness is 0.4 mm.
The settings that activate overhangs are included, the angle is 50 degrees. You can print without these settings.
Filling 15%.
The number of walls is 4.
The bridge settings are activated.
The printing speed of the walls is 42.5.
The filling speed is 60.
I wish you all successful printed models!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
