Thingiverse
Juwel EccoSkim grid insert
door Pascal-S
21
Downloads
8
Likes
0
Makes
I created a grid to put inside the floater of the EccoSkim skimmer from Juwel. Hopefully it will prevent any shrimps/little fish from getting inside.
I sliced it using PrusaSlicer and used the EccoSkim_grid_middle_part.stl to modify the interior of the EccoSkim_grid_full_insert.stl so the middle of the part prints with no top/bottom layers and just infill.
This is in my opinion the way to go, because you can use basically any infill pattern for the insert.
I had the best success with a 30% grid insert. Any higher and the skimmer wouldn't work properly anymore.
After printing you can just drop it inside the floater and maybe adjust the flow a little so the skimmer does its job.
It was designed using Fusion 360.
I sliced it using PrusaSlicer and used the EccoSkim_grid_middle_part.stl to modify the interior of the EccoSkim_grid_full_insert.stl so the middle of the part prints with no top/bottom layers and just infill.
This is in my opinion the way to go, because you can use basically any infill pattern for the insert.
I had the best success with a 30% grid insert. Any higher and the skimmer wouldn't work properly anymore.
After printing you can just drop it inside the floater and maybe adjust the flow a little so the skimmer does its job.
It was designed using Fusion 360.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
