Thingiverse
K-Drill
von keyglitch
13
Downloads
13
Likes
0
Makes
This is a visually reconstructed copy of Prusa Research's P-Drill*. The drill was a part of the i3 MK2 to MK2s upgrade and was used to enlarge the bed mounting holes for U-bolts.
The part was not included in the latest MK2.5S upgrade kit (and I couldn't find it online).
Some similarities/differences between the K-Drill and P-Drill:
* This takes a 1/8" drill bit (3.175 mm)
* Two 12mm socket cap M3 screws are used to secure the bit
* Two M3 hex nuts are inserted in the slots to capture the screws (but square nuts can also be used)
* This is the K-Drill to distinguish it from the P-Drill
\* https://manual.prusa3d.com/Guide/1.+Y-carriage+drilling/323
The part was not included in the latest MK2.5S upgrade kit (and I couldn't find it online).
Some similarities/differences between the K-Drill and P-Drill:
* This takes a 1/8" drill bit (3.175 mm)
* Two 12mm socket cap M3 screws are used to secure the bit
* Two M3 hex nuts are inserted in the slots to capture the screws (but square nuts can also be used)
* This is the K-Drill to distinguish it from the P-Drill
\* https://manual.prusa3d.com/Guide/1.+Y-carriage+drilling/323
keyglitch veröffentlicht auch auf
27 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
